...verify that the HDMI cable used is of high quality . This is particularly important for 4K 60 Hz , which requires a premium HDMI cable . 4.1.2.2 ASSIGNING A NEW SOURCE TO A SINGLE DECODER ( RX ) To assign a new source to a decoder ( RX ) , repeat...

...end of a DisplayPort cable to the DisplayPort port on the source device ( e.g . computer , server , or other IT device ) . Then connect the other end to the DP IN port located on the TX unit . 3 . Connect the DisplayPort display to the DP OUT por...

...that is , in strict accordance with the manufacturer’s instructions , may cause inter­ference to radio communication . It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in S...

...DB9 RS - 232 to RJ - 45 cable , connect a terminal or terminal emulator to the Gigabit Managed Ethernet Switch to access the command - line interface . Š Š Attach the RJ - 45 serial port on the switch’s front panel to connect to the switch for conso...

...installed and used according to the instructions in this manual , together with the specified cables and the maximum cable length < 3m , the Units : ACS2009A - R2 - MM , ACS2009A - R2 - SM , ACS2209A - R2 - MM , ACS2209A - R2 - SM ACS4001A - R2 -...

...that is , in strict accordance with the manufacturer’s instructions , may cause interference to radio communication . It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Su...

...RJ - 45 9 24 Universal cable , 4 ' ( 2 ) telco cables , 14 ' : RJ - 11 , RJ - 45 1 3 5 10 25 ⁄ 8 " x 4 " , ⁄ 32 " x 2 " , ⁄ 16 " x 4 " Telephone line tester ( 3 ) slot screwdrivers : 11 26 ( 4 ) torx drivers : T10 , T15 , T20 , T25 Pocket flashligh...

...and off , or the serial cable running close to high power lines . The isolation also helps eliminate ground loops caused by different potentials on the grounds . The ICD103A can also be used as a repeater to extend the RS - 232 signal beyond 50 feet...

...Mounting and Cable Attachment : Mbps . Adjust the 10 / 100 Mbps switch to the speed of ™ the connecting device and check for link status . The FlexPoint 10 / 100 converts between Fast Ethernet The FlexPoint 10 / 100 can be solo - mounted ...

...installed and used in accordance with the instruction manual , may cause harmful interference to radio communications . Operation of this equipment is a residential area is likely to cause harmful interference in which case the user will be required...